https://community.hpe.com/t5/netservers/netserver-e50-and-usb/m-p/3477578#M7620 try upgrading the firmware Tue, 22 Feb 2005 05:32:10 GMT Binukuttan VM_1 2005-02-22T05:32:10Z https://community.hpe.com/t5/netservers/netserver-e50-and-usb/m-p/3477576#M7618 Hello,<BR /><BR />My E50 Netserver has two USB Conectors. How can i enable the USB Ports? Units connected to the USB will not work.<BR /><BR />I need the USB port for the Dongle...<BR /><BR />thx<BR /> Thu, 03 Feb 2005 07:41:22 GMT https://community.hpe.com/t5/netservers/netserver-e50-and-usb/m-p/3477576#M7618 Falcon_3 2005-02-03T07:41:22Z https://community.hpe.com/t5/netservers/netserver-e50-and-usb/m-p/3477577#M7619 Actually there is no USB controller to run these USB ports. There is no built-in USB functionality on the E50 system board. It is the equivalent to having an external SCSI port but no SCSI controller to actually run it. There's no way to simply attach a USB controller. You can certainly try &amp; install a USB PCI card, for instance, but HP did not test this so we do not know if it will work or not.<BR />Basic system board specs: 440FX chipset. PCI spec: 2.1 Single PCI bus structure. Fri, 04 Feb 2005 16:15:15 GMT https://community.hpe.com/t5/netservers/netserver-e50-and-usb/m-p/3477577#M7619 Terri Harris 2005-02-04T16:15:15Z https://community.hpe.com/t5/netservers/netserver-e50-and-usb/m-p/3477578#M7620 try upgrading the firmware Tue, 22 Feb 2005 05:32:10 GMT https://community.hpe.com/t5/netservers/netserver-e50-and-usb/m-p/3477578#M7620 Binukuttan VM_1 2005-02-22T05:32:10Z