topic LH6000 raid.......... in Netservers

LH6000 raid..........

kazim_1 — Sat, 28 May 2005 15:31:45 GMT

One of my system HDD is fail then i replaced HDD same part number but hdd not rebuild i don't why...?
Event log not show any thing
Raid is not break , but raid not showing configration through (ctrl+m)
Message on screen then i boot this system :
NO BASE ADAPTOR AT FC 00H

THEN I REMOVE NEW HDD MY SYSTEM IS RUNNING ON A SINGLE HDD

can u plz advice me ASAP
Thanks
kazim
kazim@mushko.com
ma_kazim@yahoo.com

Re: LH6000 raid..........

amhakassa — Sat, 28 May 2005 22:46:48 GMT

Hi Kazim,

When you pop the new driv ein does it try to rebuild and stopped or just don't do nothing?

Did you saw any disk activitiy (Like flikering on the drive LEDs) when you pop the new drive in?

May be the controller is set not to Auto rebuild? boot to CTRL + M and check the controller property (Object/Adapter/Properties)

I wonder why u did not see the configuration through CTRL + M. Did you ahve a hardware mirror? if you do you should see the configuration in Netreaid express tools (which will be entered by CTRL + M)

Reseat the SCSI cable on both the controller and drive cage side.
Update the firmaware of the raid controller

Regards
Amha Kassa

Re: LH6000 raid..........

kazim_1 — Sat, 28 May 2005 23:11:17 GMT

I updated system Bios & netraid firmware

i was not rebuild through (ctrl+m) function because last few hr before i have not complete backup,

ok i will check this option then will update u.
thanks

ma_kazim@yahoo.com
Enterprise Support Engineer

Re: LH6000 raid..........

kazim_1 — Sun, 29 May 2005 01:17:00 GMT

i have check netraid rebuild through (ctrl+m)option but this option is not support to raid rebuild

then i clear the raid configration & again create raid 1

kazim

Re: LH6000 raid..........

amhakassa — Sun, 29 May 2005 01:22:23 GMT

Hi Kazim,

I hope you did not initialize the array after you recreat the array. If you did so you lost everything for sure.

But If you did not initialize the array that is good, chances are you might get the data back. The question is, when you recreat the array did you ahve the original failed drive or the new replaced drive?

In anycase you have to fail the drive that is in the slot where the drive was failed before (when you reconfigure all drives will be online so make sure you fail the drive that is in the slot where there was a drive failure)

Regards
Amha Kassa

Re: LH6000 raid..........

kazim_1 — Sun, 29 May 2005 03:32:29 GMT

when i was create a raid then i use new hdd drive

thanks for support advice
i will contact u in feature when ever i face a problem

good bye

Re: LH6000 raid..........

e4services — Sun, 29 May 2005 09:43:11 GMT

Sounds to me that you gave him bad advice.
The mirror he had was probably software and not the RAID card, that is why he saw nothing