https://community.hpe.com/t5/netservers/hpnetserver-lhr4-d6973a/m-p/3572021#M8017 I have recently had a couple of these to test. I ran HP DiagTools Ver 2.40.2 on them. 2 passed but 1 failed with system board error. I ran advanced diags and the error was "PCI Bus transfer using Bus master cycles failed" with 008A error code. Would anyone be able to tell me if this is a serious fault or if its something I'm doing wrong?? Cheers Tue, 28 Jun 2005 05:22:58 GMT william_161 2005-06-28T05:22:58Z https://community.hpe.com/t5/netservers/hpnetserver-lhr4-d6973a/m-p/3572021#M8017 I have recently had a couple of these to test. I ran HP DiagTools Ver 2.40.2 on them. 2 passed but 1 failed with system board error. I ran advanced diags and the error was "PCI Bus transfer using Bus master cycles failed" with 008A error code. Would anyone be able to tell me if this is a serious fault or if its something I'm doing wrong?? Cheers Tue, 28 Jun 2005 05:22:58 GMT https://community.hpe.com/t5/netservers/hpnetserver-lhr4-d6973a/m-p/3572021#M8017 william_161 2005-06-28T05:22:58Z https://community.hpe.com/t5/netservers/hpnetserver-lhr4-d6973a/m-p/3572022#M8018 This is a known issue and is not any actual hardware problem. DiagTools will report a system board failure when in fact the system board is really ok. The specific PCI bus error you are reporting is most commonly seen in Netservers with the NetRAID-4M controller installed. It is not, however, a problem. Fri, 01 Jul 2005 16:18:51 GMT https://community.hpe.com/t5/netservers/hpnetserver-lhr4-d6973a/m-p/3572022#M8018 Terri Harris 2005-07-01T16:18:51Z