Error message in LC2000

Mohamed Faruz — Fri, 09 Jun 2006 02:21:13 GMT

In LC2000 server an error message is coming.

0080-51 Netserver Management Controller self test failure. i have downloaded flash from hp site and executed. but the version is incompatible. my original bios revision is H. but i downloaded was revision F. so i need revision H bios

Re: Error message in LC2000

T. Vander Auwera — Mon, 12 Jun 2006 05:34:33 GMT

Hello Mohamed,

Please check the link below for some background info related to the error itself:

http://h20000.www2.hp.com/bizsupport/TechSupport/Document.jsp?lang=en&cc=us&objectID=lpn14088&jumpid=reg_R1002_USEN

Is your LC2000 equipped with a low noise fan kit?

Re: Error message in LC2000

Sean T. Craig — Wed, 14 Jun 2006 12:41:39 GMT

Hi Mohamed,

The Management Controller Self-Test failure is a known issue with a fairly easy fix:

Step #1:
Download the latest BIOS revision from the following link: http://h20000.www2.hp.com/bizsupport/TechSupport/SoftwareDescription.jsp?lang=en&cc=us&prodTypeId=15351&prodSeriesId=50440&prodNameId=19399&swEnvOID=54&swLang=13&mode=2&taskId=135&swItem=ns-10050-2
When you run the application it will ask you for one formatted floppy and ask you to specify the drive letter of the floppy drive.

Step #2
Boot from the floppy created in step #1 and choose option 1 to begin the flash update.

Step #3
Press to enter the CMOS Setup. Go to the Exit tab and choose "Clear System Configuration and Exit." You may need to re-enter setup by pressing and re-save config before proceeding.

Step #4
Boot the server from a DOS Boot floppy. If you do not have access to one, you can download an image from http://www.24by7.ca/files/boot98se.exe
*Note: this file and website are not affiliated with Hewlett Packard and using it will be at your own risk.

Step #5
From a DOS Prompt, replace the BIOS update floppy and execute the following command:
A:\> flashmmc l2km_us.bin
*Note: there is no interactive screen; the update takes place in the background. Wait for a prompt to reappear.

Step #6
When the prompt returns, execute the following command:
A:\> sdredit -w -f list_lc2k.sdr
*Note: Unlike the previous step, this one is interactive and you will see activity.

Step #7
Repeat steps #2 & 3.

When you are referring to the H & F revisions, this is for the Management Controller, not the whole system BIOS. If you have an H revision Management Controller it means that you have an LC2000 U3, not an LC2000. The current BIOS revision is 4.06.04 RM.

Hope this helps,

Sean T. Craig Sr. C.E.T., M.C.P.

topic Re: Error message in LC2000 in Netservers

Error message in LC2000

Re: Error message in LC2000

Re: Error message in LC2000