topic Re: Failed NetServer LPR in Netservers

Failed NetServer LPR

Laurence Lara — Mon, 29 Jan 2007 12:51:25 GMT

Help! We had a power outage over the weekend and our HP NetServer LPR and HP Rack Storage 12 SCSI unit did not power down gracefully. Walked in this morning and all 7 SSCI drives installed in RS 12 unit are bleaking Red! Sever will not boot up into OS. Boot screen shows following error: "Configuration of NVRAM and drives mismatch".

Sever OS: Sever 2003
Net Raid adapter bios: v. B.02.04
Net Raid-3Si adapter firmware: v. C.02.08

Thank you in advance for any help provided on this issue!

Larry.

Re: Failed NetServer LPR

Sean T. Craig — Mon, 29 Jan 2007 23:40:07 GMT

Hi Larry,

Go into NetRAID Express Tools by pressing M and select Configure-->View/Add/Delete Configuration--> and you should see NVRAM and Disk. Select Disk and wait until it's done loading up. If all the drives are online, press and choose "Yes" to save. Escape out of the utility and press to restart.

If the disks are not all online under the Disks menu, choose "No" to save and choose NVRAM. If there are still failed disks, post your config here and we'll help you straighten it out.

Good luck,

Sean T. Craig Sr. C.E.T., M.C.P.

Re: Failed NetServer LPR

Laurence Lara — Wed, 31 Jan 2007 11:36:58 GMT

Thank you for your help and quick response on this issue. Your repair advice was right on! Our NetServer is back online and functioning properly.

Once again, Thank You!

Larry.

Re: Failed NetServer LPR

Laurence Lara — Wed, 31 Jan 2007 11:39:46 GMT

I wish I could assign you more than 10 points on this issue, but once again thank's for everything...

Re: Failed NetServer LPR

Sean T. Craig — Wed, 31 Jan 2007 13:41:06 GMT

Hi Larry,

Thank you for the kind words. I too wish I could get more than 10 points. Unfortunately, you didn't give me any. Thanks anyway, though.

Sean T. Craig Sr. C.E.T., M.C.P.