topic Re: Hp Smart Array 641 error message in ProLiant Servers (ML,DL,SL)

Hp Smart Array 641 error message

Navaneeda Kumar — Sat, 27 May 2006 02:33:07 GMT

Hi,
I have a Ml370 G3 server installed with Hp Smart Array controller 641. I am facing intermediate problems, whenevr i restart the server it giving a error message in POST for the storgae controller. the error code is 1777.
Is it necessary to change the hardware or any firmware update is required??

Re: Hp Smart Array 641 error message

srinath raju — Sat, 27 May 2006 05:42:17 GMT

Hi,
All you will need to do is to upgrade the firmware and the issue will be resolved.You will be able to get the latest firmware from:
http://h20000.www2.hp.com/bizsupport/TechSupport/SupportTaskIndex.jsp?lang=en&cc=us&prodTypeId=329290&prodSeriesId=348488&taskId=110.

Regards

Srinath

Re: Hp Smart Array 641 error message

Navaneeda Kumar — Sat, 27 May 2006 06:16:26 GMT

Hi,
I am not able to access the link which youhave provided. i have downloaded the latest irmware for hp 641/642 array controller from HP website....

Re: Hp Smart Array 641 error message

srinath raju — Sat, 27 May 2006 10:58:39 GMT

Hi Navaneeda,

1- Most Likely Cause of the 1777 error is a bent pin on the scsi cable.

Check both ends of the cable for bent pins.
or change cable.

2- Overheating issues

3- Storage Encl. Backplane issues

there could be many reasons for that error, this error is reported by array controller; I would disconnect all cables to the controller and try one cable at a time; also make sure firmware is uptodate on the controller latest is 2.26d or can use 2.26b
and please let me know.

regards,
Srinath

Re: Hp Smart Array 641 error message

Navaneeda Kumar — Sat, 27 May 2006 11:07:29 GMT

hi,
the firmware from the inter i have donloaded is 2.62 lattest. is this the correct one??

Re: Hp Smart Array 641 error message

srinath raju — Sun, 28 May 2006 08:31:14 GMT

Hi,The firmware update, Version 4.12 P28, contains critical bug fixes and is the minimum version required.Try this firmware and see if the issue still persists.If so than update it with the latest one that you have downloaded. Please perform the update at your earliest convenience. Apart from updating the firware also perform the other steps that i have mentioned. This should resolve the issue.

Link: http://h18023.www1.hp.com/support/files/server/us/download/21978.html

Regards

Srinath

Re: Hp Smart Array 641 error message

srinath raju — Sun, 28 May 2006 18:30:12 GMT

Hi,
Simply power down, disconnect the power cord, remove all the drives and then remove and reseat the SCSI backplane,Bent pins. Does it go away if you press F1 until the next boot?

The SCSI backplane board is not properly seated or the Simplex / Duplex switch on the backplane is not set correctly. Set them right and possibly the issue should be resolved.

Regards

Srinath