topic Re: Backup Hardware Error 20/40 Dat in HPE ProLiant Servers (ML,DL,SL)

Backup Hardware Error 20/40 Dat

Ayman Altounji — Thu, 04 Jan 2001 00:00:00 GMT

Using Windows 2000 Built-in Backup utility, when I run a backup to tape that takes more than a few minutes, I get a "Hardware Error" or "Hardware error writing to device" form Windows 2000.
I am using the Compaq 20/40 DAT that was supplied with the server and have installed the latest available driver from Compaq.
I can backup smaller numbers of files.

Following is Backup Error log for the faied backup:
----
Backup Status
Operation: Backup
Active backup destination: 4mm DDS
Media name: "Media created 03/01/2001 at 16:43"

Backup of "D: Apps"
Backup set #1 on media #1
Backup description: "Set created 03/01/2001 at 16:47"
Backup Type: Normal

Backup started on 03/01/2001 at 19:01.

Error: The device reported an error on a request to write data to media.
Error reported: Hardware failure.

Backup completed on 03/01/2001 at 19:11.
Directories: 551
Files: 26447
Bytes: 1,600,341,023
Time: 10 minutes and 18 seconds

----------------------

and now a successful run:

----------------------

Backup Status
Operation: Backup
Active backup destination: 4mm DDS
Media name: "Media created 03/01/2001 at 09:07"

Backup of "D: Apps"
Backup set #1 on media #1
Backup description: "Set created 03/01/2001 at 09:09"
Backup Type: Normal

Backup started on 03/01/2001 at 09:10.
Backup completed on 03/01/2001 at 09:17.
Directories: 89
Files: 1239
Bytes: 1,341,713,829
Time: 7 minutes and 23 seconds

----------------------

Re: Backup Hardware Error 20/40 Dat

Ayman Altounji — Wed, 10 Jan 2001 00:00:00 GMT

What is the firmware revision on the tape drive ?
Have you run diags on the tape drive ?
What brand / type of types are you using ?
What controller is the tape drive attached ? what port ? are hard drives attached to same channel ?

Re: Backup Hardware Error 20/40 Dat

Ayman Altounji — Fri, 26 Jan 2001 00:00:00 GMT

How do I get the Firmware Rev?
How do I run Diags?
Tapes are Sony DGD150P DDS4 and FujiFilm 150M 4mm 20/40 DDS4
Drive connected to Bus 0, Target ID 6, LUN 0
No other drives - All Hard disks on Smart array 3200.

Re: Backup Hardware Error 20/40 Dat

Ayman Altounji — Thu, 29 Mar 2001 00:00:00 GMT

I had a similar problem with HI DDT connected to an Adapted 2940 SCSI controller. To solve this I down loaded the driver for the SCSI adapter from Adapted and replaced the Windows 2000 SCSI driver with this one.

Good luck
/Daniel