Problemas {ML110 Gen9 server problems}

Fabioalmeida — Thu, 28 Nov 2019 06:32:36 GMT

Bom dia, Estou com um servidor HP ProLiant ML110 Gen9 que liga e depois de uns 5 minutos desliga e so vai liga no dia seguinte, ja fiz varias pesquisas consultei alguns colegas que trabalham na área e niguem sabe me dizer o que ta acontecendo. Por isso vim aqui pedir sugestões? O pior Não me mostra o que ta causando o desligamento, nem no ilo.

Google Translation 
Good morning, I have an HP ProLiant ML110 Gen9 server that turns on and after about 5 minutes turns off and only goes on the next day,
I've done a lot of research consulted some colleagues who work in the area and nobody can tell me what's going on. 
That's why I came here to ask for suggestions? 
The worst It does not show me what is causing the shutdown, not ilo.

Re: Problemas {ML110 Gen9 server problems}

SanjeevGoyal — Thu, 28 Nov 2019 07:36:42 GMT

Hello,

I would request you clear the NVRAM , follow the below instruction.

HPE ProLiant ML110 Gen9 Server (Page No 11-12)

https://h20628.www2.hp.com/km-ext/kmcsdirect/emr_na-c04605708-5.pdf

Position Default Function
S6 Off Off = No function
On = ROM reads system
configuration as invalid.
S7 Off Off = Set default boot mode to UEFI.
On = Set default boot mode to legacy.
S8 — Reserved
S9 — Reserved
S10 — Reserved
S11 — Reserved
S12 — Reserved
To access the redundant ROM, set S1, S5, and S6 to On.
When the system maintenance S6 switch is set to the On position, the system will erase all system
configuration settings from both CMOS and NVRAM on the next reboot.
CAUTION: Clearing CMOS and/or NVRAM deletes configuration information. Be sure to
properly configure the server or data loss could occur.
Before using the S7 switch to change the boot mode to Legacy BIOS Mode, you must first disable the
Dynamic Smart Array B140i Controller.
To disable the Dynamic Smart Array B140i Controller:
1. Reboot the server.
The server restarts and the POST screen appears.
2. Press F9.
The System utility screen appears.
3. Select System Configuration → BIOS/Platform Configuration (RBSU) → System Options →
SATA Controller Options → Embedded SATA Configuration, and then press Enter.
4. Select Enable SATA AHCI Support, and then press Enter.
5. Press F10 to save the selection.
6. Press Y to save the changes.
The Change saved confirmation prompt appears.
7. Select Exit and resume system boot, and press Enter.
The server continues the normal boot process.

After that update the server bios with the latest.

If you feel this was helpful please click the KUDOS! thumb below!

Regards,

topic Re: Problemas {ML110 Gen9 server problems} in HPE ProLiant Servers (ML,DL,SL)

Problemas {ML110 Gen9 server problems}

Re: Problemas {ML110 Gen9 server problems}