topic iloamp fails to upgrade firmware on Gen9 with SUT error in HPE ProLiant Servers (ML,DL,SL)

iloamp fails to upgrade firmware on Gen9 with SUT error

vjrk83 — Tue, 22 Mar 2022 07:25:23 GMT

Hello,

Working on upgrading the firmware via ILO amp and seeing error as below.

SPP Update job failed because SUT is not installed/responding. iLO Error Response: iLO Response Message: There is no valid session established with the implementation. Resolution: Establish as session before attempting any operations.

Please advise !

Query: iloamp fails to upgrade firmware on Gen9 with SUT error

support_s — Wed, 16 Mar 2022 18:24:07 GMT

System recommended content:

1. Advisory: (Revision) HPE OneView - A Full Firmware Update on HPE ProLiant Gen9 XL-Servers in Offline Mode May Fail with the Error Message, "The Firmware Update Operation Failed. Unable to Boot the SPP Due to Failures with Virtual Media Mount"

Please click on "Thumbs Up/Kudo" icon to give a "Kudo".

Thank you for being a HPE valuable community member.

Re: Query: iloamp fails to upgrade firmware on Gen9 with SUT error

vjrk83 — Wed, 16 Mar 2022 18:32:13 GMT

Is there any HPE advisory for ILO Amplifier ?
version : 1.81

Re: iloamp fails to upgrade firmware on Gen9 with SUT error

Cali — Fri, 18 Mar 2022 11:43:28 GMT

Hi,

you have to configure SUT on the Server (One Time only), check out my Article:

Simplified Driver and Firmware Update with iLO 5
https://d8tadude.com/2021/01/28/simplified-driver-and-firmware-update-with-ilo-5/

btw. iLO Amp 2.x is out, but there is no Update from 1.x

Cali

Re: Query: iloamp fails to upgrade firmware on Gen9 with SUT error

vjrk83 — Fri, 18 Mar 2022 13:15:05 GMT

Running SUT status on the server is giving this error.

SUT is not supported on pre-Gen10(Gen9/Gen8) systems.

Re: iloamp fails to upgrade firmware on Gen9 with SUT error

vjrk83 — Fri, 18 Mar 2022 13:17:40 GMT

I have updated the ILO AMp to the latest version 2.12 and seeing the same error now.

Running SUT status on the sever which is aGen9 running ESXi 7.0u3c is showing this error

SUT is not supported on pre-Gen10(Gen9/Gen8) systems.

Re: iloamp fails to upgrade firmware on Gen9 with SUT error

AmRa — Tue, 22 Mar 2022 07:23:24 GMT

Does the host was discovered in ILO amplifier with ILO IP address or hostname?

If the host is discovered in iLO amplifier with hostname then remove the host from iLO amplifer and readd the host with iLO IP address.

Later perform the firmware upgrade and share the observation for further action.