https://community.hpe.com/t5/proliant-servers-ml-dl-sl/cannot-see-shared-storage/m-p/2483431#M2059 If this didn't fix the problem, let us know - email support@compaq.com Fri, 23 Feb 2001 00:00:00 GMT Ayman Altounji 2001-02-23T00:00:00Z https://community.hpe.com/t5/proliant-servers-ml-dl-sl/cannot-see-shared-storage/m-p/2483429#M2057 System is out of box with 1x 18GB in each node (temp) and 4x18GB in shared storage. <BR />Should the SCSI card in node 1 see the CR3500 as an attached device at boot up? Currently, it reports no attached devices. HELP? Wed, 17 Jan 2001 00:00:00 GMT https://community.hpe.com/t5/proliant-servers-ml-dl-sl/cannot-see-shared-storage/m-p/2483429#M2057 Ayman Altounji 2001-01-17T00:00:00Z https://community.hpe.com/t5/proliant-servers-ml-dl-sl/cannot-see-shared-storage/m-p/2483430#M2058 Continue... It is very important that you check for each node the SCSI ID. The SCSI ID must be different on each node. For example : Node1 has SCSI Controller on port 1 with SCSI ID 6 and on port 2 SCSI ID 7. For Node 2 SCSI Controller on port 1 with SCSI ID 7 and on port 2 SCSI ID 6. This way you will not have SCSI errors our strange faults. Wed, 31 Jan 2001 00:00:00 GMT https://community.hpe.com/t5/proliant-servers-ml-dl-sl/cannot-see-shared-storage/m-p/2483430#M2058 Ayman Altounji 2001-01-31T00:00:00Z https://community.hpe.com/t5/proliant-servers-ml-dl-sl/cannot-see-shared-storage/m-p/2483431#M2059 If this didn't fix the problem, let us know - email support@compaq.com Fri, 23 Feb 2001 00:00:00 GMT https://community.hpe.com/t5/proliant-servers-ml-dl-sl/cannot-see-shared-storage/m-p/2483431#M2059 Ayman Altounji 2001-02-23T00:00:00Z