https://community.hpe.com/t5/proliant-servers-ml-dl-sl/errors-after-installing-smp/m-p/2467739#M243 I install and license SCO SMP and allow it to relink the kernel. When I reboot, the console displays the error "WARNING: apic - no BIOS information found for irq 1" (the same entry is put in the messages file immediately before the first "%disk" entry). The system then finishes booting, but the keyboard is inop. <BR /> <BR />This is not good. Any help? Tue, 28 Nov 2000 00:00:00 GMT Ayman Altounji 2000-11-28T00:00:00Z https://community.hpe.com/t5/proliant-servers-ml-dl-sl/errors-after-installing-smp/m-p/2467739#M243 I install and license SCO SMP and allow it to relink the kernel. When I reboot, the console displays the error "WARNING: apic - no BIOS information found for irq 1" (the same entry is put in the messages file immediately before the first "%disk" entry). The system then finishes booting, but the keyboard is inop. <BR /> <BR />This is not good. Any help? Tue, 28 Nov 2000 00:00:00 GMT https://community.hpe.com/t5/proliant-servers-ml-dl-sl/errors-after-installing-smp/m-p/2467739#M243 Ayman Altounji 2000-11-28T00:00:00Z https://community.hpe.com/t5/proliant-servers-ml-dl-sl/errors-after-installing-smp/m-p/2467740#M244 Turns out upgrading the system's BIOS (P09) to the latest version did the trick. Tue, 28 Nov 2000 00:00:01 GMT https://community.hpe.com/t5/proliant-servers-ml-dl-sl/errors-after-installing-smp/m-p/2467740#M244 Ayman Altounji 2000-11-28T00:00:01Z https://community.hpe.com/t5/proliant-servers-ml-dl-sl/errors-after-installing-smp/m-p/2467741#M245 For the SCO SMP kernel to work correctly with the system, you must set the processor APIC mode to "Full Table" in the system BIOS. Thu, 30 Nov 2000 00:00:00 GMT https://community.hpe.com/t5/proliant-servers-ml-dl-sl/errors-after-installing-smp/m-p/2467741#M245 Ayman Altounji 2000-11-30T00:00:00Z