topic Re: Error code 0x4,0x1,0,0 during Windows 2000 setup in ProLiant Servers (ML,DL,SL)

Error code 0x4,0x1,0,0 during Windows 2000 setup

Jorge_82 — Tue, 05 Oct 2004 16:35:03 GMT

Hi

help...

i have the Error code 0x4,0x1,0,0 during Windows 2000 setup

why??...please help me!

Re: Error code 0x4,0x1,0,0 during Windows 2000 setup

Tarek Kawach — Tue, 05 Oct 2004 16:54:58 GMT

Hi Jorge:

here you go:

Error Code `(0x4, 0x1, 0, 0)` Encountered During The Windows 2000 Setup Process On ProLiant Servers

customer advisory EM030131_CW03 revision 0
released February 2003

http://h20000.www2.hp.com/bizsupport/TechSupport/Document.jsp?objectID=PSD_EM030131_CW03

Tarek.

Re: Error code 0x4,0x1,0,0 during Windows 2000 setup

Jorge_82 — Tue, 05 Oct 2004 17:28:29 GMT

the Microsoft page:

"Install hotfix documented in Q283891 into your source setup files or setup diskettes, and then restart setup."

but i cant found it..Q283891

I format with Fdisk DOS boot disk, but nothing happend...

Why in the smartstart report 15 equal Scsi disk ??Â¿?
-->
Scsi 1 controller slot 1 36.4GB ...
Scsi 2 controller slor 1 36.4GB....
...
Scsi 15 controller slot 1 36.4

Re: Error code 0x4,0x1,0,0 during Windows 2000 setup

Tarek Kawach — Tue, 05 Oct 2004 17:58:51 GMT

are these hotplug or non hotplug drives
- what controller are they connected to.

If hotplug drives; scsi id is given by the SCSI backplane;

If not hotplug drives; make sure that all drives have different scsi id. (this is done with jumpers on the scsi drive.

I could not find the MS article listed also. Q283891 ??

that is documeneted in MS article.

Re: Error code 0x4,0x1,0,0 during Windows 2000 setup

Jorge_82 — Tue, 05 Oct 2004 18:03:28 GMT

I only have one disk scsi...

but show 15 scsi disk different with same ID....

Re: Error code 0x4,0x1,0,0 during Windows 2000 setup

Terry Hutchings — Tue, 05 Oct 2004 18:27:17 GMT

This is usually showing this way (all scsi ids show the same device) because of a scsi id conflict. What is the scsi id of the drive?

Re: Error code 0x4,0x1,0,0 during Windows 2000 setup

Brian Murdoch — Wed, 06 Oct 2004 11:20:59 GMT

Hi,

As Terry has pointed out this is normally due to a disk with SCSI ID 7 (i.e. the same as the controller). It's either a cable fault (bent pins) or the drive has all the ID jumpers installed.

I hope this helps,

Brian