https://community.hpe.com/t5/proliant-servers-ml-dl-sl/adic-tape-device/m-p/2497023#M3735 Try moving the tape drive to one of the other Servers to verify the tape drive is working , if so, make comparsions with the drives , drivers and software setup . Tue, 27 Mar 2001 00:00:00 GMT Ayman Altounji 2001-03-27T00:00:00Z https://community.hpe.com/t5/proliant-servers-ml-dl-sl/adic-tape-device/m-p/2497022#M3734 I've got an ADIC device that shows the SCSI ID for the ADIC on a reboot, but does not find the Quantum ID 3. This works on 2 other Proliant 2500 units. Is there anything I can check to correct this? The tape drive does not appear in NT Control Panel so I cannot properly configure it within ArcServe. Thu, 22 Feb 2001 00:00:00 GMT https://community.hpe.com/t5/proliant-servers-ml-dl-sl/adic-tape-device/m-p/2497022#M3734 Ayman Altounji 2001-02-22T00:00:00Z https://community.hpe.com/t5/proliant-servers-ml-dl-sl/adic-tape-device/m-p/2497023#M3735 Try moving the tape drive to one of the other Servers to verify the tape drive is working , if so, make comparsions with the drives , drivers and software setup . Tue, 27 Mar 2001 00:00:00 GMT https://community.hpe.com/t5/proliant-servers-ml-dl-sl/adic-tape-device/m-p/2497023#M3735 Ayman Altounji 2001-03-27T00:00:00Z