https://community.hpe.com/t5/hpe-proliant-servers-ml-dl-sl/not-auto-rebuilding-array/m-p/2594584#M8828 it still sounds like the array controller...try flashing it to the latest rom (options rompaq for array controllers) and see if it clears anything up Thu, 22 Nov 2001 00:00:00 GMT Mark Cloutier 2001-11-22T00:00:00Z https://community.hpe.com/t5/hpe-proliant-servers-ml-dl-sl/not-auto-rebuilding-array/m-p/2594583#M8827 I have a Proliant 2500 with a Smart 2-P controller. The same hard drive has been replaced 4 times and has always failed within a few weeks. the backplane, raid card and cable have been replaced. now when you bootup it asks if you want to auto rebuild, press f2, it starts to do this but after 5 minutes the online light goes out, no lights active except when drives are accessed then all three lights flash, even on the failed drive. On reboot it again detects failed array. Any ideas? Sun, 14 Oct 2001 23:00:00 GMT https://community.hpe.com/t5/hpe-proliant-servers-ml-dl-sl/not-auto-rebuilding-array/m-p/2594583#M8827 Ayman Altounji 2001-10-14T23:00:00Z https://community.hpe.com/t5/hpe-proliant-servers-ml-dl-sl/not-auto-rebuilding-array/m-p/2594584#M8828 it still sounds like the array controller...try flashing it to the latest rom (options rompaq for array controllers) and see if it clears anything up Thu, 22 Nov 2001 00:00:00 GMT https://community.hpe.com/t5/hpe-proliant-servers-ml-dl-sl/not-auto-rebuilding-array/m-p/2594584#M8828 Mark Cloutier 2001-11-22T00:00:00Z