topic Re: P410i Controller running at 100% CPU usage in ProLiant Servers (ML,DL,SL)

P410i Controller running at 100% CPU usage

Jason_212 — Tue, 02 Feb 2010 16:09:48 GMT

I noticed that on my new DL360G6 servers (running windows 2003) that the HP Homepage shows the P410i controller's "CPU Usage" is running at 100% eventhough the server is not doing anything. I am running 8.30 SupportPaq. Anybody seen this or have a recommendation?

Re: P410i Controller running at 100% CPU usage

Pete2010 — Wed, 03 Feb 2010 04:22:32 GMT

Make sure it has all of the latest Firmware. the 410i should be at 2.74.

http://h20000.www2.hp.com/bizsupport/TechSupport/SoftwareIndex.jsp?lang=en&cc=us&prodNameId=3884320&prodTypeId=15351&prodSeriesId=3884319&swLang=13&taskId=135&swEnvOID=1005#7813

Re: P410i Controller running at 100% CPU usage

Mark Coney — Thu, 04 Feb 2010 15:45:30 GMT

I updated to the current version 2.74, we will see how it goes after we can get a reboot

Re: P410i Controller running at 100% CPU usage

Doug_77 — Fri, 05 Feb 2010 00:28:06 GMT

I am setting up a brand new dl380 g6 and have the latest software (2.74) for the P410i controller and I am still getting 100% usage in the HP Managment viewer? Also some of the graphics (like drive capacity limits) show up as a red X. Any ideas.

Sorry for the thread jack. But this was the only one I found with info on the P410i 100% usage problem.

Thanks

Doug

Re: P410i Controller running at 100% CPU usage

gabryp — Thu, 18 Feb 2010 11:47:30 GMT

the same problem...

Re: P410i Controller running at 100% CPU usage

marcus1234 — Fri, 19 Feb 2010 22:42:12 GMT

boot from fw cr 8.7 update all firmware
not use psp pack cd 8.3 update all drivers

reboot if issue persists remove cache and battery from controller
it wil complain

reboot again add cache no battery let it complete post , make sure cache is on tight
reboot add battery too now reboot and enjoy:)

if issue persists boot from software cd and run diagnostics in survey mode and then adu rapport post it here i will look at it

This is how we thank each other in the forum

http://forums11.itrc.hp.com/service/forums/helptips.do?#33

Enjoy:)

Re: P410i Controller running at 100% CPU usage

Taifur — Sat, 20 Feb 2010 05:34:46 GMT

Hi,

U can check that issue by using upgraded firmware and use minimum process from ur OS

Cheers,
Taifur

Re: P410i Controller running at 100% CPU usage

Erdogan Temur — Wed, 24 Feb 2010 09:31:12 GMT

Hi,

Controller card Cache Status have been Permanently Disabled ?

Re: P410i Controller running at 100% CPU usage

ddaloia — Fri, 26 Feb 2010 13:05:14 GMT

Reset the System Bios (not the array bios) back to Defaults and reboot server. This fixed the issue for my BL460c G6 with the P410i controller. I noticed today HP removed driver version 6.18.2.64 from their website for Windows 2008 x64. 6.18.0.64 seems to be the latest at this point.

Cheers.