topic Removing one member from a stack in Switches, Hubs, and Modems

Removing one member from a stack

psycho.chicken — Mon, 08 Jan 2007 16:54:52 GMT

How do i remove a member from a stack?

I'm following a HP Doc but some of the commands arent showing up/working

Via CLI or Menu is fine

Re: Removing one member from a stack

Matt Hobbs — Mon, 08 Jan 2007 18:02:16 GMT

Through the web interface it's very straight forward from memory.

Otherwise from the CLI you could try 'no stack' and then 'stack auto-join' to renable it.

Or do 'no stack join '

When you do 'show run' it will show you the mac-address of the Commander that you need to specify.

Alternatively from the Commander going through the telnet Menu, you can go into the stack management menu and delete the switch from there.

Re: Removing one member from a stack

psycho.chicken — Mon, 08 Jan 2007 18:34:47 GMT

I figured it out...

I was noton the commander, so all the options were not available...

dah...