topic Re: Layer 3 switching in Switches, Hubs, and Modems

Layer 3 switching

Karthikeyan_5 — Tue, 12 Aug 2003 01:58:53 GMT

Hi all

I am using 2 HP 5304 L3 switch & trying to configure OSPF routing .i need to know whether HP switch's support zero support,ifso what's the command to enable that.i tried my best it's not accepting.

Re: Layer 3 switching

Joaquin Gil de Vergara — Tue, 12 Aug 2003 06:49:26 GMT

i think is
# conf t

ip subnet-zero

setting OSPF is like a cisco router!

Re: Layer 3 switching

Ardon — Tue, 12 Aug 2003 09:56:18 GMT

Hi,

The IP Subnet Zero command applies to Cisco boxes or 93XX but not the 53XX. I just configured 10.10.10.1/9 (255.128.0.0) which is 1 Bit for Subnetting and the 53XX (E.07.30) accepts it. SO what range were you trying to configure? What was the error message?

Thanks, Ardon

Re: Layer 3 switching

Karthikeyan_5 — Wed, 13 Aug 2003 11:29:02 GMT

IP-subnet zero ,i tried already but it's not picking up.even i upgraded the flash to the latest version E_07_30.

Is it advisable to use zero subnet?