https://community.hpe.com/t5/switches-hubs-and-modems/upgrading-to-3500yl/m-p/4254162#M15330 Hi Jon,<BR /><BR />The configuration should only show commands that are different from the default settings. My suspicion is that if the proper mappings are showing up in the dscp-map, they must have already existed in the default mappings. The qos dscp-map 101110 priority 6 shows up because it is different than what was in the default mappings. <BR /><BR />Regards,<BR /><BR />Jarret Wed, 20 Aug 2008 13:46:10 GMT Jarret Workman 2008-08-20T13:46:10Z https://community.hpe.com/t5/switches-hubs-and-modems/upgrading-to-3500yl/m-p/4254161#M15329 Our network consists mostly of 3400's.<BR /><BR />I just got a 3500yl<BR /><BR />When I "show config" I see most of my configuration as I would expect it, but the config doesn't show the dscp-map as it did on the 3400's. Instead it is only showing one line of the map:<BR /><BR />qos dscp-map 101110 priority 6<BR /><BR />When I "show qos dscp-map" I can see that all the priority mappings have 'stuck' after reboot, but I'm concerned that I'm missing something. Is this normal behavior?<BR /><BR />Thanks.. Mon, 18 Aug 2008 20:34:21 GMT https://community.hpe.com/t5/switches-hubs-and-modems/upgrading-to-3500yl/m-p/4254161#M15329 Jon Forna 2008-08-18T20:34:21Z https://community.hpe.com/t5/switches-hubs-and-modems/upgrading-to-3500yl/m-p/4254162#M15330 Hi Jon,<BR /><BR />The configuration should only show commands that are different from the default settings. My suspicion is that if the proper mappings are showing up in the dscp-map, they must have already existed in the default mappings. The qos dscp-map 101110 priority 6 shows up because it is different than what was in the default mappings. <BR /><BR />Regards,<BR /><BR />Jarret Wed, 20 Aug 2008 13:46:10 GMT https://community.hpe.com/t5/switches-hubs-and-modems/upgrading-to-3500yl/m-p/4254162#M15330 Jarret Workman 2008-08-20T13:46:10Z