topic Re: Create a basic VLAN on Procurve 2848 in Switches, Hubs, and Modems

Create a basic VLAN on Procurve 2848

Teleporte — Wed, 23 Mar 2011 10:34:22 GMT

Hi! I'm trying to make 2 VLANS in my switch, before i was a cisco switch and i had 2 vlans "by ports" that works really well but now im trying to make the same thing on HP Swith but i can't.

I dont wanna make trunk, routing, or something else, just "isolate" a few port from default VLAN and use it like a separated switch.

My current config (that it's not working) is:

Running configuration:

; J4904A Configuration Editor; Created on release #I.10.77

hostname "ProCurve Switch 2848"
ip default-gateway 192.168.0.1
snmp-server community "secret" Unrestricted
vlan 1
name "DEFAULT_VLAN"
untagged 1-32,45-48
ip address 192.168.0.180 255.255.255.0
no untagged 33-44
exit
vlan 10
name "VLAN_10"
untagged 33-38
no ip address
voice
exit
"vlan 20
name "VLAN_20"
untagged 39-44
no ip address
exit
fault-finder bad-driver sensitivity high
fault-finder bad-transceiver sensitivity high
fault-finder bad-cable sensitivity high
fault-finder too-long-cable sensitivity high
fault-finder over-bandwidth sensitivity high
fault-finder broadcast-storm sensitivity high
fault-finder loss-of-link sensitivity high
fault-finder duplex-mismatch-HDx sensitivity high
fault-finder duplex-mismatch-FDx sensitivity high
no stack
password manager
password operator

---------------------------------------------

Please help!
thanks

Re: Create a basic VLAN on Procurve 2848

showneek — Wed, 23 Mar 2011 12:08:03 GMT

Hi! If you only want to have local isolated vlan (10, 20) so there is no other communication needed for them or between them except between untagged ports in this vlan then your config should work. Just assign ip addresses to clients in this vlan (connect DHCP to vlan or set manually). No default gateway needed because communication is isolated only between vlan ports.

If you need communication between vlans or anywhere from this switch you have to span vlans to router (tag uplink ports) or configure ip routing and then possibly make some filtering through ACLs.

Re: Create a basic VLAN on Procurve 2848

Pieter 't Hart — Fri, 25 Mar 2011 14:56:51 GMT

vlan 10
untagged 33-38
exit

Is all that's needed to isolate some ports in a separate (v) lan.

why it's not working?
maybe no need to issue an "apply" command, before the changes are activated?