https://community.hpe.com/t5/switches-hubs-and-modems/pcm-error-in-network-map/m-p/5118864#M28292 Closing Fri, 11 Jul 2008 08:36:36 GMT J Vesterdahl 2008-07-11T08:36:36Z https://community.hpe.com/t5/switches-hubs-and-modems/pcm-error-in-network-map/m-p/5118862#M28290 Hi all.<BR />At one place in my network I used to have two 2824 switches connected directly by singlemode fiber. A while ago a 2824 was inserted between the two, it's now a two-hop link.<BR />PCM+ added the two new connections in the network map, but did not remove the old direct link.<BR />Oddly enough, the error is only in the overall network map. The VLAN maps are fine.<BR /><BR />PCM+ 2.3 update 5<BR />2824 firmware I.10.43<BR /><BR />Any thoughts? Fri, 11 Jul 2008 08:31:51 GMT https://community.hpe.com/t5/switches-hubs-and-modems/pcm-error-in-network-map/m-p/5118862#M28290 J Vesterdahl 2008-07-11T08:31:51Z https://community.hpe.com/t5/switches-hubs-and-modems/pcm-error-in-network-map/m-p/5118863#M28291 Okay - delete device and rediscover did the trick once again.<BR />I deleted the most remote device, and after manual rediscovery, PCM got the map right. Fri, 11 Jul 2008 08:35:33 GMT https://community.hpe.com/t5/switches-hubs-and-modems/pcm-error-in-network-map/m-p/5118863#M28291 J Vesterdahl 2008-07-11T08:35:33Z https://community.hpe.com/t5/switches-hubs-and-modems/pcm-error-in-network-map/m-p/5118864#M28292 Closing Fri, 11 Jul 2008 08:36:36 GMT https://community.hpe.com/t5/switches-hubs-and-modems/pcm-error-in-network-map/m-p/5118864#M28292 J Vesterdahl 2008-07-11T08:36:36Z