topic Re: need wireless and cisco solution in Communications and Wireless

need wireless and cisco solution

mansoor_3 — Sat, 01 May 2004 14:25:11 GMT

hi
this mansoor fro ksa
i want to ask one question.
we have internal network over cisco 6506 multilayer backbone and end switches with catalyst 3500.again we wireless routers from lucent technology and these routers are connected with mountain radio tower and from there it connecting to over branch offices.we one wireless remote router and each location

problem :if i connect remoter router located inside the head office through uplink port of 100 mbps and again at the branch i will connect remote router with switch uplink port to carry trunk information
is it possible or not or pls give me the solutiion
thank you

Re: need wireless and cisco solution

Ron Kinner — Tue, 04 May 2004 08:57:48 GMT

Your translation program is not working very well but it appears you want to connect your internal network via some sort of microwave to the LAN of your remote branches. A diagram (with part numbers) would be a good idea to show us what you want to do.

Do you know the bandwidth of the radio connection? How does it connect to the switch or router? It is a serial link or is the radio equipped with an Ethernet connection? If it has an Ethernet connection does it get an IP address on each end or is it transparent to IP?

How many VLANs are involved? What kind of computers are in the network?

Ron

Re: need wireless and cisco solution

mansoor_3 — Wed, 05 May 2004 12:23:34 GMT

Hi
thanks for your response
i will tell u in detail and i will send u visio diagram .
but first we have Lan with backbone 6506 cisco switch.this is connected with the end switches catalyst 3500 through gibic ports in different zones .now vlans are running locally
but we have remote sites through wave line
right now the remote router is connected with the one of the ethernet port of the end switch.( the remote router also has ethernet port which is connected with the ethernet port of the end switch 100mbps )
AND THIS REMOTE ROUTER IS AGAIN CONNECTED WITH RADIO TRANSMITTER WITH A SPECIAL CABLE AND ONE MORECABLE IS GOING TO CONNECT WITH THE ANTENNA FROM TANSMITTER.THIS ANTENNA IS DIRECTED TO THE MOUNTAIN WHERE WE RADIO TRANSMISSION TOWER.THIS TOWER HAS TWO ANTENNA WHIS COVERS THE SIGNAL WITHIN 25KM OF THE AREA.
IT HAS 11MBPS BACNDWIDTH

AT THE REMOTE BRANCH WE HAVE THE SAME.SETUP
ANTENNA IS DIRECTED TO THE MOUNTAIN ANTENNA AND FROM ANTENNA IT IS CONNECTED WITH RADIO TRANSMITTER AND FORM THE TRANSMITTER IT IS CONNECTING TO THE REMOTE ROUTER ( BRIDGE )
AND THIS REMOTE ROUTER IS CONNECTED WITH TH E HUB BY ETHERNET PORT

IMP:NOW THE TRAFFIC IS PASSING THROUGH EHTERNET PORT OF THE SWITCH AND OF COURSE IT CANNOT CARRY THE TRUNK INFORMAION.
WE WANT TO KEEP EACH REMOTE SITE IN A SEPARATE VLAN

WE HAVE NO SUBNETS AND NO ROUTING ALL ARE JUST LIKE A LAN

PLS GIVE ME THE SUGGESTIONS
THANKS A LOT FOR YOUR RESPONSE
AND AM EXPECTING YOUR REPLY V.SOON
BYE