https://community.hpe.com/t5/communications-and-wireless/wl-410/m-p/3437712#M3500 I found these instructions on the web maybe it can help you. Let me know if this helps you out in case I run into a WL-410 Thu, 09 Dec 2004 13:04:40 GMT Fernando D. Flores 2004-12-09T13:04:40Z https://community.hpe.com/t5/communications-and-wireless/wl-410/m-p/3437711#M3499 I have an old WL-410 Access Point that I need to configure and use as a bridge.<BR /><BR />Problem is, I can't get into the configuration 'AP Manager'. It comes up with the factory IP address 153.69.254.254, but I can't get any further. It asks for a new IP address, which I assign it an address withing my internal range, then it asks for the read/write SNMP string, 'public'. When I enter that, it then comes up with, this device is not an Access Point. <BR /><BR />Any ideas or help? Mon, 06 Dec 2004 20:38:44 GMT https://community.hpe.com/t5/communications-and-wireless/wl-410/m-p/3437711#M3499 Jason Bischoff_1 2004-12-06T20:38:44Z https://community.hpe.com/t5/communications-and-wireless/wl-410/m-p/3437712#M3500 I found these instructions on the web maybe it can help you. Let me know if this helps you out in case I run into a WL-410 Thu, 09 Dec 2004 13:04:40 GMT https://community.hpe.com/t5/communications-and-wireless/wl-410/m-p/3437712#M3500 Fernando D. Flores 2004-12-09T13:04:40Z