topic Re: HP Integrity RX2660 Boot Problem in Integrity Servers

HP Integrity RX2660 Boot Problem

chocoteco — Wed, 03 Jun 2015 20:06:57 GMT

The rx2660 server doesnt have signal video.

The status leds are the next:

Power LED : Steady green

External health LED : Steady green

Internal health LED : Steady green

System health LED : Blink between red and amber. one minute blinks red and the next blinks amber

Re: HP Integrity RX2660 Boot Problem

S_Logan — Thu, 04 Jun 2015 05:42:29 GMT

Hi,

Please acknowledge and view the MP SL and FPL Logs.

You Can switch to the MP console by pressing CTRL+B , then login to MP and view the logs from MP:CM> prompt

Re: HP Integrity RX2660 Boot Problem

S_Logan — Thu, 04 Jun 2015 05:44:18 GMT

Hi,

You can capture the SL logs and update here.

Let us look in to that

Re: HP Integrity RX2660 Boot Problem

S_Logan — Thu, 04 Jun 2015 05:48:32 GMT

Please find the LED Status as updated:

Power LED = Green: full power is ON
System health LED = Flashing amber: warning / Flashing red: system fault
Internal health LED = Green: system health is good
External health LED = Green: system health is good

Re: HP Integrity RX2660 Boot Problem

chocoteco — Thu, 04 Jun 2015 21:27:35 GMT

I am not be able to see nothing in the monitor... No signal video and not signal in the VGA port (console output).

It has been tried with two different monitors.

iLO 2 MP LAN heartbeat

Standby power LED

BMC heartbeat are blinking normally.

Re: HP Integrity RX2660 Boot Problem

S_Logan — Fri, 05 Jun 2015 11:39:10 GMT

Hope the display configured to VGA port. Normally it should be connected to Serial console to view the MP Logs.

If you power recycle , are able to see few startup screens?

Re: HP Integrity RX2660 Boot Problem

S_Logan — Fri, 05 Jun 2015 11:42:43 GMT

Hi,

i understand the console out put connected to VGA, in this case you wont be seeing the progress happening after some time, even you can see the mesaage console configure to serial then the cursor will be blinking continously.

Please confirm , is this happening in your case. if so , we need to configure the console to re direct the output to VGA.

Re: HP Integrity RX2660 Boot Problem

S_Logan — Fri, 05 Jun 2015 11:45:32 GMT

Hi,

If Console configuration needed, please refer the following links:

HP Integrity rx2660, rx3600, and rx6600 Servers - How Is Console Output Configured?
http://h20565.www2.hp.com/hpsc/doc/public/display?sp4ts.oid=3346452&docId=emr_na-c01479528&docLocale=en_US

HP Integrity rx2660 Servers - Configuring the iLO 2 MP LAN Using the RS-232 Serial Port
http://h20564.www2.hp.com/hpsc/doc/public/display?docId=emr_na-c02250882