Help for setting hpilo serial

uxbeginner22 — Fri, 27 Nov 2015 15:26:25 GMT

i want to configure hpilo serial.

Maybe someday i lost ip connection.

I have bought this cable

On laptop (linux) i see

[ 1628.533984] usb 1-1: new full-speed USB device number 2 using xhci_hcd
[ 1628.698668] usb 1-1: New USB device found, idVendor=1a86, idProduct=7523
[ 1628.698674] usb 1-1: New USB device strings: Mfr=0, Product=2, SerialNumber=0
[ 1628.698676] usb 1-1: Product: USB2.0-Ser!
[ 1628.699122] ch341 1-1:1.0: ch341-uart converter detected
[ 1628.699918] usb 1-1: ch341-uart converter now attached to ttyUSB0

On minicom side i use 9600 bn1 software

On hpilo (CA command) list

Current Local Serial Port Configuration:
     Bit Rate in bits/sec           : 9600
     Flow Control                   : Software


Current Remote/Modem Serial Port Configuration:
     Bit Rate in bits/sec           : 38400
     Flow Control                   : Software
     Modem Presence                 : Always connected
     Modem Protocol                 : CCITT
     Transmit Configuration Strings : Enabled

But no prompt on minicom,why?

Re: Help for setting hpilo serial

Bill Hassell — Mon, 30 Nov 2015 00:39:48 GMT

You need a null modem adapter for the cable you are using.

topic Re: Help for setting hpilo serial in Integrity Servers

Help for setting hpilo serial

Re: Help for setting hpilo serial