topic Re: Itanium rx4640 memory installation procedures in Integrity Servers

Itanium rx4640 memory installation procedures

Joe Profaizer — Fri, 18 Nov 2005 12:35:05 GMT

I'm trying to find the procedures for memory installation for an rx4640. I believe there is a method to the madness (install DIMMS in pairs), and need to find the document.

For instance slot 0A and 2B reported failures and I need to know if I just change those two DIMMS out or have to replace the respective DIMM's partner.

Any help is appreciated.

Re: Itanium rx4640 memory installation procedures

Devender Khatana — Fri, 18 Nov 2005 12:48:58 GMT

Hi,

Here is the document

http://www2.itrc.hp.com/service/cki/docDisplay.do?docLocale=en_US&docId=200000079760598

HTH,
Devender

Re: Itanium rx4640 memory installation procedures

Torsten. — Fri, 18 Nov 2005 12:50:17 GMT

What is the error message?

The memory is installed in quads (4 dimms, e.g. installed in 0a,0b,0c,0d).

The error message should show you the single dimm which has errors. it's usually enough to replace this one.

Re: Itanium rx4640 memory installation procedures

Andy Torres — Fri, 18 Nov 2005 14:30:29 GMT

In addition to the technical knowledge base article mentioned above, here's a link to the "HP Integrity rx4640 Operations Guide", which states under hardware specifications:

"Supports up to eight Double Data Rate (DDR) registered ECC Memory, in PC1600 DIMMs. Supported DDR DIMM sizes: 128MB, 256MB, 513MB, 1GB, 2GB, and 4GB. Requires DIMMs to be added in quads of equal capacity."

http://docs.hp.com/en/rx4640_ops/rx4640_ops.pdf

Re: Itanium rx4640 memory installation procedures

Steven E. Protter — Sat, 19 Nov 2005 13:32:47 GMT

It would seem that you have one of two problems:

1) One of the new DIMM's is bad, replace is the obvious answer.

2) The pairs are not going in in the prpper paird slots. Seems from the already posted doc's a bunch of DIMM's might have to go in as a foursome.

In Integrity and PA-RISC servers pairs/quads only work in certain memory slots. You just can't put in four and hope, you have to know where to put the four.

I used to solve that problem by putting the same memory in all available slots. It gave me a headache trying to figure out which memory slots worked in pairs with others.

Still this may just be one bad chip. HP should be willing to ship you a replacement to see. Or whereever you got the memory.

SEP