topic Re: rx8640 memory problem in Integrity Servers

rx8640 memory problem

MárcioAFM — Wed, 22 Oct 2008 17:58:35 GMT

Hello,

I have a rx8640 with one Partition (Partition 0) that have 3 cell's. In this partition i have 3 vPars. There was a energy problem and the only two partitions boot the vPar3 doesn't go up because says that have no memory. I tried to assign with vaprmodify memory but the return is no memory available.
I have a problem in cell 2 (3 VRM's in fault), do you think that can cause the server not to see the memory?

Best Regards,

Marcio

Re: rx8640 memory problem

Sameer_Nirmal — Wed, 22 Oct 2008 19:15:08 GMT

It depends on the vpar3 setup and the status of cell 2 assuming vpar3 was setup using it.

What do you see in
# vparstatus
# vpartstatus -p vpar3 -v

Re: rx8640 memory problem

Kishore Anand — Fri, 24 Oct 2008 01:19:30 GMT

Please provide the following: -

1. MP:CM> ps (For all entity)

2. The output of the script attached.

Re: rx8640 memory problem

Torsten. — Fri, 24 Oct 2008 05:51:50 GMT

"I have a problem in cell 2 (3 VRM's in fault), do you think that can cause the server not to see the memory?"

Due to the problems with cell2 you may have disabled memory = less memory than needed.

Contact HP support to get the H/W problem solved.

Re: rx8640 memory problem

Torsten. — Fri, 24 Oct 2008 06:06:00 GMT

To get more status info run this:

# echo "sel dev all;info;wait;il"|cstm

Re: rx8640 memory problem

MárcioAFM — Fri, 24 Oct 2008 08:08:01 GMT

Hello all,

Thank you for the help, i asked for a new cell and replacd all the VRM's. After this no problem... everything goes uo okay.

Thanks you

MÃ¡rcio

Re: rx8640 memory problem

MárcioAFM — Fri, 24 Oct 2008 08:09:26 GMT

Hello all,

Thank you for the help, i asked for a new cell and replacd all the VRM's. After this no problem... everything goes uo okay.

Thanks you

Marcio