topic Re: MP Errors in Integrity Servers

MP Errors

AZayed — Mon, 23 Feb 2009 17:02:54 GMT

Dears,

Good day,

We have HP rx7620. recently I noticed that it is printing the following errors on the console :

"failed to get new net buffer for received packet"

"failed to get new net cluster for received packet"

I don't know why this error appears, but I can't ping the MP or telnet.

Can you help me?

Thanks in advance.

Re: MP Errors

sujit kumar singh — Mon, 23 Feb 2009 19:16:01 GMT

Hi

then i assume that you are getting these messages in the MP Serial console as you said that you are not able to ping or telnet ot the MP.

So you are geeting these messages in the MP Serial console.

For Ping or Telnet MP issues: if you are able to accesss the MP serila console:

1) check the physical connection of the LAN cable connectd to MP LAN Port, and to the switch that this LAN cable goes, Check the Routing.
2)Serially accessing the MP try to see the MP LAN config
MP>CM
MP:CM>LC
3)see the access config of MP
MP:CM>SO (Security Option)
MP:CM>CA (Console Acess)
4)Try by restartingthe MP
MP:CM>XD --- followed by R.

etc

for the above HP-UX messages also have allok at the syslogs.

Re: MP Errors

AZayed — Mon, 23 Feb 2009 20:13:08 GMT

Hi,

Thanks for reply, the server was configure from April 2007 and we didn't touch it. Maybe the restart will help. If I restart MP it will restart MP only not the System because I'm working here on production server.

Is there any way to control/access MP from HP-UX ?

Regards,

Re: MP Errors

Dennis Handly — Mon, 23 Feb 2009 20:56:53 GMT

>If I restart MP it will restart MP only not the System because I'm working here on production server.

Yes you can do that.

>Is there any way to control/access MP from HP-UX?

Only by telnet to it. On some GSPs you could do:
http://forums.itrc.hp.com/service/forums/questionanswer.do?threadId=1158493

Re: MP Errors

AZayed — Wed, 25 Feb 2009 16:14:23 GMT

The restart solve the problem