topic Re: Help with boot from SAn Bl35p in Windows Server 2003

Help with boot from SAn Bl35p

pardelinha — Thu, 31 Aug 2006 09:02:47 GMT

Hello.
I am try to configure a BL35p to boot from SAN (MSA100) and i get an error i don't undestand.
" The hard disk containing the partition or free space has a LUN greater than 0. Setup cannot install windows on this disk"
The blade has an Emulex FC. The configuratios is:
- Bios active.
- Boot device configured
- Autoscan disabled
- Topologu P2P
- Othe confs by default

Can anyone help me?
Thanks in advance.
Pedro

Re: Help with boot from SAn Bl35p

sandeep_raman — Sun, 03 Sep 2006 12:42:28 GMT

Hello pardelinha,

Hope this has some information,

http://h20000.www2.hp.com/bc/docs/support/SupportManual/c00580093/c00580093.pdf

SRH

Re: Help with boot from SAn Bl35p

Albert Austin — Mon, 02 Oct 2006 08:49:52 GMT

Did you manage to solve this issue? I have run into the same problem.
Heres a link to my thread.

http://forums1.itrc.hp.com/service/forums/questionanswer.do?threadId=1064376

Albert

Re: Help with boot from SAn Bl35p

Wade Fleet — Thu, 05 Jul 2007 22:48:10 GMT

Hi guys,

Was this ever resolved as I am trying to solve this issue myself...

anybody have a solution.

Regards

Wade

Re: Help with boot from SAn Bl35p

dave rowland_2 — Sat, 13 Oct 2007 04:17:16 GMT

try zoning the switch so there is only one path for the build, you can then zone for the other paths AFTER you have installed the MPIO (multipath) driver