topic Re: Need help with Alphaserver 1000A, OpenVMS install in Operating System - OpenVMS

Need help with Alphaserver 1000A, OpenVMS install

n7ihb — Wed, 08 Oct 2014 03:02:53 GMT

Have a legacy system on a DEC/Compaq Alphaserver 1000A. Server died and crashed the system drive, bought a replacement server (old one was a 1000, new one is 1000A but I was assured that they are compatible) and when I try to re-install OpenVMS OS, I get the following:

halt code =5

HALT instruction executed

PC = 2000f918.

Using the same install CD originally used to install the OS (by someone else before my time, not here any more).

Had planned on re-installing OS and restoring to last backup tape of the server.

Any help would be appreciated.

P.S. This thread has been moved from Business Support Web Site to OpenVMS > System Management. - Hp Forum Moderator

Re: Need help with Alphaserver 1000A, OpenVMS install

Richard Brodie_1 — Wed, 08 Oct 2014 09:44:55 GMT

They are compatible, mostly. However, you might need a more recent version of VMS to run on the 1000A. There is a minimum version table available from HPs site. You didn't say the exact model or the version you were trying to install.

Re: Need help with Alphaserver 1000A, OpenVMS install

GuentherF — Wed, 08 Oct 2014 15:28:03 GMT

What was the command to boot from the CD?

/Guenther

Re: Need help with Alphaserver 1000A, OpenVMS install

Hoff — Wed, 08 Oct 2014 15:37:44 GMT

You're probably below the minimum OpenVMS version for whichever particular AlphaServer 1000A box is involved here, or there's potentially a hardware problem with the new box. Without the system model, OpenVMS Alpha version and/or enough of the console output, which means I can't confirm that this version requirement is the case, unfortunately. But it's the usual trigger.

Re: Need help with Alphaserver 1000A, OpenVMS install

Peter Elliott — Thu, 09 Oct 2014 08:23:17 GMT

It's been a long time since I saw one of these - but have you checked the console value for "os_type"

>>> os_type OpenVMS

This system may have previously been used to run Unix and the value may be set to OSF !

Re: Need help with Alphaserver 1000A, OpenVMS install

Hoff — Thu, 09 Oct 2014 12:11:43 GMT

re: Peter Elliott's reference to OS_TYPE

The OS_TYPE environment variable is certainly a necessary step and a good check.

The four that are most commonly involved:

>>> show BOOTDEF_DEV
>>> show BOOT_OSFLAGS
>>> show OS_TYPE
>>> show BOOT_FILE

FWIW, the systems with the Unix SRM settings usually show a APB-F-BADSYSROOT, System root [SYSA.] does not exist error during the VMS boot.

I'd (still) suspect this is a minimum-supported-version problem, as the OP has already received some bad advice around the relative sameness of the AlphaServer 1000A and the AlphaServer 1000. Among the salient hardware differences, the 1000A does have vastly faster integrated graphics, but I digress...