topic SSH & SCP is not working in Operating System - OpenVMS

SSH & SCP is not working

Chand Basha — Fri, 16 Dec 2005 16:09:43 GMT

Multinet Process software
SSH & SCP is working fine for SYSTEM account on VMS but not for normal accounts.

When I try to login it asks for password over and over again.

One of the sshd.log file says that
WARNING: sshd2-auth: The client requested authentication method 'keyboard-interactive', that is not allowed for user `sftpuser'.

Please help.

Thanks,
Chand

Re: SSH & SCP is not working

Arch_Muthiah — Fri, 16 Dec 2005 18:25:35 GMT

Hi Chand,

Check this file SSH2_DIR:SSHD2_CONFIG and make sure the values against the following keywords AllowedAuthentications,AllowUsers, and AuthInteractiveFailureTimeout.

I think the specofic user name should be listed in "AllowUsers" category

Archunan

Re: SSH & SCP is not working

Chand Basha — Sat, 17 Dec 2005 10:13:47 GMT

I checked the log file, the AllowedAuthentications parameter is having the value as publickey,password. And the AllowedUsers is commented out and the last parameter AuthInteractiveFailureTimeout is not present in the configuration file.

SSH and SCP is working fine in development machine but it is not working in production. The configuration file is same for both.

When I debug the ssh command, after entering the password it is failing in the SSHAUTHC.C routine.
The error message is
debug: (08:04:57)Ssh2AuthPasswdClient/AUTHC-PASSWD.C;2:68: auth_password op = 3
user = bashac
debug: (08:04:57)Ssh2AuthClient/SSHAUTHC.C;1:600: process_failure cont = 0

Re: SSH & SCP is not working

Wim Van den Wyngaert — Mon, 19 Dec 2005 02:55:01 GMT

May be this helps.
http://www.ssh.com/support/documentation/online/ssh/adminguide/43/User_Authentication_with_Keyboard-Interactive.html

Wim

Re: SSH & SCP is not working

Richard Whalen — Mon, 19 Dec 2005 09:01:25 GMT

Add "keyboard-interactive" to the list of AllowedAuthentications in SSH2_DIR:SSHD2_CONFIG.

Also make sure that the protection of SSH2_DIR:SSHD2_CONFIG. allows the user to read the file.

Re: SSH & SCP is not working

Chand Basha — Mon, 19 Dec 2005 14:41:30 GMT

The issue was the account on production was not having remote access.

Problem is resolved.

Thanks for your replys on this thread