topic Re: Networking on Open VMS using CHARON VAX in Operating System - OpenVMS

Networking on Open VMS using CHARON VAX

Bob Lusk — Fri, 11 Feb 2005 10:12:33 GMT

I am attempting to use the CHARON VAX emulator on a PC to replace a VAX 4000. I have been trying to use both ports on the HP/COMPAQ NC3122 dual port LAN card with no success. Any advice?

Re: Networking on Open VMS using CHARON VAX

Volker Halle — Fri, 11 Feb 2005 10:42:43 GMT

Bob,

in general, you need to install the CHARON-VAX ndis5 network packet driver and activate this driver/protocol on one of the 2 NIC cards as the only protocol (de-active all other network protocol bindings on that card).

Then add the name of that card into the CHARON-VAX .CFG file.

Cold you please describe what kind of error/problem you are seeing and what exactly you were doing ?

Volker.

Re: Networking on Open VMS using CHARON VAX

Kris Clippeleyr — Fri, 11 Feb 2005 10:44:48 GMT

Hi Bob,

Being no expert on CHARON VAX, but browsing the net, I found something about "Configuring multiple Ethernet adapters in CHARON-VAX" at http://www.softresint.com/charon-vax/app_notes.htm#rn

Hope this helps,
Kris (aka Qkcl)

Re: Networking on Open VMS using CHARON VAX

Bob Lusk — Fri, 11 Feb 2005 13:46:06 GMT

Volker

There are multiple ways to enter LAN information in the .cfg file. One way is with a simple name string (i.e. load ndis5_packet_port XQB0 interface="3Com EtherLink XL 10/100 PCI For Complete PC Management NIC (3C905C-TX) #3") or by the specification of a long ugly hex numeric string (i.e. load ndis5_packet_port eza_0 interface="\Device\Packet_{2B585F2A-8058-4AB4-8D12-26473422AA01}".

Thanks,
Bob

Re: Networking on Open VMS using CHARON VAX

Bob Lusk — Fri, 11 Feb 2005 13:47:20 GMT

See the reply to Volker. It all comes down to the documentation.