topic Re: Disable network device on LLA0 in Operating System - OpenVMS

Disable network device on LLA0

Sentosa — Fri, 23 Mar 2007 01:46:25 GMT

Dear All,

We are using LLA0 (EIA0 -active, EIB0) for LAN device.

I want to perform failover test by command level instead of un-plug cable. Could anyone know how to do in command level?

I have tried to issue "ucx set dev EIA0/disable" but not successful.

Thanks & Regards,
Sentosa

Re: Disable network device on LLA0

Jon Pinkley — Fri, 23 Mar 2007 02:15:32 GMT

$ mc lancp set device/switch lla0

should do what you want.

$ mc lancp help set device /switch

SET

DEVICE

/SWITCH

/SWITCH (SET DEVICE only)

Forces a LAN failover to another member of the LAN Failover set.

You can test LAN failover operation by using this command to
switch from one device to another.

-----------------------

Also see the following forum thread

http://forums1.itrc.hp.com/service/forums/questionanswer.do?threadId=1000984

Re: Disable network device on LLA0

Sentosa — Fri, 23 Mar 2007 02:25:08 GMT

Hi Jon Pinkley,

I tested successfully.
Thank you very much.

Regards,
Sentosa