https://community.hpe.com/t5/operating-system-openvms/decserver-700/m-p/3565822#M69053 Hi Geir,<BR />I don't understand if you already used that decserver. If yes, you don't need special cable on port 1; VT and cable used for emulation is enough. In this case you can also open console port via decnet<BR />$ MC NCP CONN VIA <LINE> PHYS ADDR <MAC_ADDR><BR />If you decserver is new (refurbished) device,<BR />I'm afraid it's reset to factory default.<BR /> <BR />Antonio Vigliotti<BR /><BR /></MAC_ADDR></LINE> Fri, 17 Jun 2005 01:53:01 GMT Antoniov. 2005-06-17T01:53:01Z https://community.hpe.com/t5/operating-system-openvms/decserver-700/m-p/3565821#M69052 Hi,<BR /><BR />I have trouble to configure an old DECserver 700. The problem is that I can not access the console port. I suppose that I must use rolled over cable, and connect it to a VT-terminal, or PC on port 1. <BR /><BR />The LED lamp is always blinking green, but I cannot find information about the meaning. Maybe the DECserver is reset to factory settings? What should I do to continue the configuration?? Fri, 17 Jun 2005 01:40:44 GMT https://community.hpe.com/t5/operating-system-openvms/decserver-700/m-p/3565821#M69052 geir_2 2005-06-17T01:40:44Z https://community.hpe.com/t5/operating-system-openvms/decserver-700/m-p/3565822#M69053 Hi Geir,<BR />I don't understand if you already used that decserver. If yes, you don't need special cable on port 1; VT and cable used for emulation is enough. In this case you can also open console port via decnet<BR />$ MC NCP CONN VIA <LINE> PHYS ADDR <MAC_ADDR><BR />If you decserver is new (refurbished) device,<BR />I'm afraid it's reset to factory default.<BR /> <BR />Antonio Vigliotti<BR /><BR /></MAC_ADDR></LINE> Fri, 17 Jun 2005 01:53:01 GMT https://community.hpe.com/t5/operating-system-openvms/decserver-700/m-p/3565822#M69053 Antoniov. 2005-06-17T01:53:01Z