topic SHOW NET in Operating System - OpenVMS

SHOW NET

Taulant Shamo — Mon, 05 Sep 2005 07:10:46 GMT

Hello,

When I issue the command SHOW NET the printout is:
SCCRA2$ show net

Product: DECNET Node: SCCRA2 Address(es): 59.12
Product: TCPWARE Node: Address(es):

The IP in not configured (I did a mess) whether in other node is configured.

SCCRA1$ show net

Product: DECNET Node: SCCRA1 Address(es): 59.11
Product: TCPWARE Node: SCCRA1.VODAFONE.AL Address(es): 127.0.0.1 10.5
.13.97 /MASK=255.255.255.224

HOw can I define the IP and Masks and gateway t thant node

Thanks

Re: SHOW NET

Peter Quodling — Mon, 05 Sep 2005 07:33:23 GMT

This is the HP Itrc forum. While it deals with VMS and VMS related things, the VMS TCPIP product is different from the Process Software Corporation's "TCPWARE" Product - as such you would stand a much better chance. Go to www.process.com, select service and support, select documentation,
select the installation guide. Read it, particularly chapter 3, (in particular if you read around page 3-3, it will explain how to change IP addresseses, although I would suggest a read of the whole book, if you don't know what you are doing, or haven't done this before. Preferably before you start installing software and trying to configure it.

Peter

Re: SHOW NET

Ian Miller. — Mon, 05 Sep 2005 07:44:37 GMT

The information displayed by SHOW NETWORK is dependent on setup being done by SYS$STARTUP:SYS$NET_SERVICES.COM which looks for SYS$STARTUP:SYS$NET_SERVICES_*.COM so there should be a SYS$STARTUP:SYS$NET_SERVICES_TCPWARE.COM to register the appropriate information.

If the IP address is now configured (but was not when the system started) then try
@SYS$STARTUP:SYS$NET_SERVICES.COM

Re: SHOW NET

Geoff Bryant — Tue, 06 Sep 2005 10:33:23 GMT

You should run CNFNET:

$ @TCPWARE:CNFNET