topic Re: decnet address in Operating System - OpenVMS

decnet address

vmsserbo — Thu, 15 Sep 2005 11:25:45 GMT

What is the command on a VAX server that gives you the decnet address/routing number of the node?
Thanks!

Re: decnet address

Uwe Zessin — Thu, 15 Sep 2005 11:33:07 GMT

It depends on the version:
$ show network
$ mcr ncp show executor characteristics
$ mcr ncl ? [ don't know for Phase V, sorry]

Re: decnet address

vmsserbo — Thu, 15 Sep 2005 11:35:40 GMT

tHANKS!

Re: decnet address

Jan van den Ende — Thu, 15 Sep 2005 12:06:55 GMT

Phase V:

$ mcr ncl show node 0 char all

Proost.

Have one on me.

jpe

Re: decnet address

Mike Reznak — Fri, 16 Sep 2005 01:07:10 GMT

Hi,

better to use pipe if you have higher version than V6.*
And even in Decnet OSI (phase V) it's possible to use
$ pipe mc ncp sh exec char | sea sys$input executor
to get the address.

Mike

Re: decnet address

Wim Van den Wyngaert — Fri, 16 Sep 2005 01:14:11 GMT

Remove char from Jan's ncl answer. And node 0 is optional. And it doesn't show the address ...

The answer is :
$ mc ncl sho rou pha add

Wim

Re: decnet address

Wim Van den Wyngaert — Fri, 16 Sep 2005 01:55:24 GMT

But that depends on phase4 so better to do
$ mc decnet_register show node xxx
where xxx is the node name.
You will see all addresses defined for the node.

Wim

Re: decnet address

Michael Yu_3 — Sun, 18 Sep 2005 21:04:44 GMT

Hi,

If running phase V, then ...

NCL> show all id

shows the name and all the address tower sets for the node, including DECnet over IP.

Thanks and regards.

Michael

Re: decnet address

Maurille Emmanuel — Tue, 11 Oct 2005 06:45:27 GMT

Hye,

show net -> give you the decnet address
mc ncl show routing phaseiv address -> for the phaseiv prefix address

Emmanuel

Re: decnet address

Daniel Fernandez Illan — Tue, 11 Oct 2005 09:57:20 GMT

Hi

Phase V
To see routing configuration:
TYPE SYS$STARTUP:NET$ROUTING_STARTUP.NCL

or
MC NCL SHO ROUTING PHASE IV ADDRESS

Saludos.
Daniel.