https://community.hpe.com/t5/operating-system-openvms/help-w-m2402-nsr-reconfig/m-p/4328594#M92626 The manual, my hours of trying, and HP support has failed me on this seemingly simple change.<BR /><BR />Present config:<BR />Module 0: 2-port fC<BR />Module 1: unused<BR />Module 2: 4-port SCSI for HP Jukebox (newer)<BR />Module 3: 4-port SCSI for HP Jukebox (older)<BR /><BR />I need to remove the jukebox on Module 3 &amp; leave the one on Module 2. My present map includes both with the jukebox to be removed having the lower luns.<BR /><BR />I have created a new map based on the present map. I deleted the lower luns, which defined the older Jukebox, &amp; clicked on "remove gaps". Then disconnected older juke &amp; repowered everything.<BR /><BR />The "discovery" display shows my new mapping with the newer jukebox's components showing up as "active".<BR /><BR />Problem: the "discovery" display shows the older juke interspersed with the newer juke, with its components listed as "not avail", and I can't make the nsr stop looking for the old juke!<BR /><BR />I have gone to the exent of deleting all maps (except the defaults) and any map assignments to hosts. The only thing I haven't tried is the "reset to factory defaults".<BR /><BR />How can I get the m2402 to "forget" about devices that were previously defined? Wed, 24 Dec 2008 17:11:30 GMT Jack Trachtman 2008-12-24T17:11:30Z https://community.hpe.com/t5/operating-system-openvms/help-w-m2402-nsr-reconfig/m-p/4328594#M92626 The manual, my hours of trying, and HP support has failed me on this seemingly simple change.<BR /><BR />Present config:<BR />Module 0: 2-port fC<BR />Module 1: unused<BR />Module 2: 4-port SCSI for HP Jukebox (newer)<BR />Module 3: 4-port SCSI for HP Jukebox (older)<BR /><BR />I need to remove the jukebox on Module 3 &amp; leave the one on Module 2. My present map includes both with the jukebox to be removed having the lower luns.<BR /><BR />I have created a new map based on the present map. I deleted the lower luns, which defined the older Jukebox, &amp; clicked on "remove gaps". Then disconnected older juke &amp; repowered everything.<BR /><BR />The "discovery" display shows my new mapping with the newer jukebox's components showing up as "active".<BR /><BR />Problem: the "discovery" display shows the older juke interspersed with the newer juke, with its components listed as "not avail", and I can't make the nsr stop looking for the old juke!<BR /><BR />I have gone to the exent of deleting all maps (except the defaults) and any map assignments to hosts. The only thing I haven't tried is the "reset to factory defaults".<BR /><BR />How can I get the m2402 to "forget" about devices that were previously defined? Wed, 24 Dec 2008 17:11:30 GMT https://community.hpe.com/t5/operating-system-openvms/help-w-m2402-nsr-reconfig/m-p/4328594#M92626 Jack Trachtman 2008-12-24T17:11:30Z