topic Re: DS10 reset itself in Operating System - OpenVMS

DS10 reset itself

wong seng guan — Sun, 26 Mar 2006 21:39:48 GMT

Gentleman,

I have Compaq Alphaserver DS10 with version OpenVMS 7.3-1 and TCPware 5.6-2.

Recently i encounter DS10 reset on itself and message log appeared as below:

%SYSTEM-F-DEVOFFLINE, device is not in configuration or not available BufCleanup:Start cleaning up small buffers for task 5! BufCleanup:Cleaned up 2 small buffer for task 5!

Plese advice me above problem.

Thanks

Re: DS10 reset itself

Karl Rohwedder — Mon, 27 Mar 2006 00:10:42 GMT

The DEVOFFLINE message is a standard VMS error message, just indicating what it says: a device is no longer reachable.

HELP/MESSAGE DEVOFFLINE

DEVOFFLINE, device is off line

Facility: OPCOM, Operator Communication Process

Explanation: This message is displayed on the operator's console when a
device goes off line in the OpenVMS system configuration.

User Action: Take appropriate measures to bring the device on line.

The BUFCLEAN seems to be from an applicacation?

Pls. check, if any device errors had been logged (SHO ERROR, DIAGNOSE) to detect which device is missing. A SHOW DEVIVE [D] may also help.

regards Kalle

Re: DS10 reset itself

Karl Rohwedder — Mon, 27 Mar 2006 01:13:22 GMT

You wrote 'reset itself', did the DS10 reboot/crash? Perhaps a dump was written, you may check with ANA/DUMP or look at the CLUE file in SYS$ERRORLOG.

Kalle

Re: DS10 reset itself

Peter Zeiszler — Tue, 28 Mar 2006 14:06:51 GMT

Check Dump files.

Check if anything showed up in the WEBES or Decevent logs. This shows hardware errors. I use webes so I don't have the decevent commands.

I don't have the exact command but its something like "anal/error" on some of the older systems.

Did the system reboot itself or halt on the boot sequence?
At the boot prompt - show dev and show. Did the boot disk disappear?