topic Riloe II - How to reset Card in Server Management - Remote Server Management

Riloe II - How to reset Card

Wildatom — Wed, 01 Jun 2005 12:39:58 GMT

Issue: I can't talk to the card with HPONCFG, and locked out by not knowing the password when pressing F8.

Help Wanted: How can I reset the card physically? Is there a jumper or something on the Riloe ii?

Re: Riloe II - How to reset Card

acartes — Wed, 01 Jun 2005 17:45:01 GMT

Confused: RILOE II does not have an F8 password. It does have tha ability to hide the F8 prompt.

What is the nature of the problem with HPONCFG? This normally would be a good way to work this issue.

Are you sure this is RILOE II or is this iLO? In iLO systems, there is an "iLO Security Override Switch" documented on the hood sticker. With power removed, set this switch, and then power up. You will have full access to all iLO configuration then. Make sure you power-off then restore the switch when you are done.

Re: Riloe II - How to reset Card

pratap m keshava — Wed, 06 Jul 2005 08:29:51 GMT

If it is RILOE II, you can set both jumper 3 and 4 in SW2 as shown in the figure attached. This will reset the RILOE II to factory default.

Re: Riloe II - How to reset Card

Wildatom — Wed, 06 Jul 2005 10:30:42 GMT

Thank You, just what I was looking for.