https://community.hpe.com/t5/server-management-remote-server/ilo-not-responding-after-reset-network-settings/m-p/3647321#M1557 Just forgot, I also installed HP management pack 7.30 and the newest bios version on ILO. Wed, 12 Oct 2005 02:00:19 GMT Cees_3 2005-10-12T02:00:19Z https://community.hpe.com/t5/server-management-remote-server/ilo-not-responding-after-reset-network-settings/m-p/3647320#M1556 Hi all,<BR /><BR />I have a server in a remote location and ILO (integrated ILO on Proliant DL380 G3) was not used. Now I want to use ILO, so I let the network port patched. Because I didn't knew any settings of ILO I used HPONCFG to reset the password, reset the whole ILO board, and set the IP settings to a fixed IP address. Then I rebooted ILO and rebooted the server as well. When I used HPONCFG to GET the IP address info, I see the settings are correct. But I still cannot ping the ILO board, or connect via HP Management in Windows. Is there something I forgot? Thanks in advance for your reaction.<BR /><BR />Kind regards,<BR />Cees Wed, 12 Oct 2005 01:57:54 GMT https://community.hpe.com/t5/server-management-remote-server/ilo-not-responding-after-reset-network-settings/m-p/3647320#M1556 Cees_3 2005-10-12T01:57:54Z https://community.hpe.com/t5/server-management-remote-server/ilo-not-responding-after-reset-network-settings/m-p/3647321#M1557 Just forgot, I also installed HP management pack 7.30 and the newest bios version on ILO. Wed, 12 Oct 2005 02:00:19 GMT https://community.hpe.com/t5/server-management-remote-server/ilo-not-responding-after-reset-network-settings/m-p/3647321#M1557 Cees_3 2005-10-12T02:00:19Z