https://community.hpe.com/t5/server-management-remote-server/riloe-ii-firmware-upgrade-error/m-p/3203405#M342 Sean, switch 3 and the rompaq disk should correct the problem unless there is a physical problem with the board. Is there a message when the flash starts from the disk or does it say no board found? Fri, 26 Mar 2004 15:28:48 GMT Junior Yharte 2004-03-26T15:28:48Z https://community.hpe.com/t5/server-management-remote-server/riloe-ii-firmware-upgrade-error/m-p/3203402#M339 Trying to upgrade firmware from 1.11 to 1.12 on several RILOE II's. All succeeded but one, and I've tried all the steps to reconfigure the card (DR mode, reset to factory settings). Any help or suggestions? Thu, 26 Feb 2004 12:53:04 GMT https://community.hpe.com/t5/server-management-remote-server/riloe-ii-firmware-upgrade-error/m-p/3203402#M339 Sean Fitzpatrick 2004-02-26T12:53:04Z https://community.hpe.com/t5/server-management-remote-server/riloe-ii-firmware-upgrade-error/m-p/3203403#M340 Can you be more specific as to the error youâ re getting? Does the rompaq (diskette) upgrade fail as well? You can force it by flipping switch 3 on the R-II and booting up w/ the firmware disket Wed, 10 Mar 2004 11:36:55 GMT https://community.hpe.com/t5/server-management-remote-server/riloe-ii-firmware-upgrade-error/m-p/3203403#M340 Junior Yharte 2004-03-10T11:36:55Z https://community.hpe.com/t5/server-management-remote-server/riloe-ii-firmware-upgrade-error/m-p/3203404#M341 Yes, I tried that as well, with no luck. Right now I have set switches 3 and 4 to on to bypass the error but I still need to reconfigure the card. The error I get when all switches are set to normal is 'Error 10002: The card is not responding', or similar wording. Fri, 12 Mar 2004 10:28:33 GMT https://community.hpe.com/t5/server-management-remote-server/riloe-ii-firmware-upgrade-error/m-p/3203404#M341 Sean Fitzpatrick 2004-03-12T10:28:33Z https://community.hpe.com/t5/server-management-remote-server/riloe-ii-firmware-upgrade-error/m-p/3203405#M342 Sean, switch 3 and the rompaq disk should correct the problem unless there is a physical problem with the board. Is there a message when the flash starts from the disk or does it say no board found? Fri, 26 Mar 2004 15:28:48 GMT https://community.hpe.com/t5/server-management-remote-server/riloe-ii-firmware-upgrade-error/m-p/3203405#M342 Junior Yharte 2004-03-26T15:28:48Z