https://community.hpe.com/t5/server-management-remote-server/lo100-retrieving-power-status-over-clp-telnet-ssh/m-p/4401049#M4345 Hello,<BR /><BR />I'm trying to retrieve the power status of ML115G5/LO100 boxes via the CLP using telnet or ssh, without success so far!<BR /><BR />I'm able to successfully power up and power down the device via the CLP using comamnds 'start /system1' and 'stop /system1' etc.<BR /><BR />However, for the system1 property 'enabledstate' is always set to 'enabled', regardless if the system is powered up or down.<BR /><BR />My expectation from reading ILO materials is that the property 'enabledstate' should be set to 'disabled' if the machine is powered up.<BR /><BR />Any suggestions?<BR /><BR /> Wed, 15 Apr 2009 07:11:56 GMT Kiroban 2009-04-15T07:11:56Z https://community.hpe.com/t5/server-management-remote-server/lo100-retrieving-power-status-over-clp-telnet-ssh/m-p/4401049#M4345 Hello,<BR /><BR />I'm trying to retrieve the power status of ML115G5/LO100 boxes via the CLP using telnet or ssh, without success so far!<BR /><BR />I'm able to successfully power up and power down the device via the CLP using comamnds 'start /system1' and 'stop /system1' etc.<BR /><BR />However, for the system1 property 'enabledstate' is always set to 'enabled', regardless if the system is powered up or down.<BR /><BR />My expectation from reading ILO materials is that the property 'enabledstate' should be set to 'disabled' if the machine is powered up.<BR /><BR />Any suggestions?<BR /><BR /> Wed, 15 Apr 2009 07:11:56 GMT https://community.hpe.com/t5/server-management-remote-server/lo100-retrieving-power-status-over-clp-telnet-ssh/m-p/4401049#M4345 Kiroban 2009-04-15T07:11:56Z