https://community.hpe.com/t5/server-management-remote-server/cpqlodos-exe/m-p/3269313#M465 hi all<BR /><BR />after a configuration change in the ilo board ( enable passtrough ) , ilo reseted not properly.<BR />the ilo board is no longer reachable by the network.<BR />i can still connect the host server of this ilo board.<BR />I tried to execute the CPQLODOS from the cmd prompt on the ilo host server.<BR />-&gt; ERROR: No RILOE/RILOE II/iLO was found.<BR />whats wrong ?<BR />or any other how to's , for remotly "reboot / reset " the iloboard ?<BR /><BR />thanks Thu, 06 May 2004 04:36:41 GMT Roger_94 2004-05-06T04:36:41Z https://community.hpe.com/t5/server-management-remote-server/cpqlodos-exe/m-p/3269313#M465 hi all<BR /><BR />after a configuration change in the ilo board ( enable passtrough ) , ilo reseted not properly.<BR />the ilo board is no longer reachable by the network.<BR />i can still connect the host server of this ilo board.<BR />I tried to execute the CPQLODOS from the cmd prompt on the ilo host server.<BR />-&gt; ERROR: No RILOE/RILOE II/iLO was found.<BR />whats wrong ?<BR />or any other how to's , for remotly "reboot / reset " the iloboard ?<BR /><BR />thanks Thu, 06 May 2004 04:36:41 GMT https://community.hpe.com/t5/server-management-remote-server/cpqlodos-exe/m-p/3269313#M465 Roger_94 2004-05-06T04:36:41Z https://community.hpe.com/t5/server-management-remote-server/cpqlodos-exe/m-p/3269314#M466 Almost sounds like iLO got disabled ...do you get the F8 prompt in POST? There will also be a message that iLO has been disabled if this is the case. You will need to set the security over-ride switch to get around this. It is documented on the inside of the server hood (cover). Let me know if you still need some help. Thu, 06 May 2004 10:54:08 GMT https://community.hpe.com/t5/server-management-remote-server/cpqlodos-exe/m-p/3269314#M466 Junior Yharte 2004-05-06T10:54:08Z