https://community.hpe.com/t5/server-management-remote-server/ilo2-not-responding/m-p/4507753#M4694 Hi All,<BR /><BR />We have a DL360 G6 server, i'm no more able to access the ILO2. When startying the server we will get the following message:<BR />Waring ILO2 not responding<BR /><BR />Cheking /var/log/messages we noticed the below messages:<BR /><BR />hpilo 0000:01:04.2: Closing, but controller still active<BR /> hpilo 0000:01:04.2: Open could not dequeue a packet<BR /><BR /><BR />Your response is highly appreciated.<BR /><BR />Thanks<BR /> Mon, 05 Oct 2009 10:21:36 GMT M.S 2009-10-05T10:21:36Z https://community.hpe.com/t5/server-management-remote-server/ilo2-not-responding/m-p/4507753#M4694 Hi All,<BR /><BR />We have a DL360 G6 server, i'm no more able to access the ILO2. When startying the server we will get the following message:<BR />Waring ILO2 not responding<BR /><BR />Cheking /var/log/messages we noticed the below messages:<BR /><BR />hpilo 0000:01:04.2: Closing, but controller still active<BR /> hpilo 0000:01:04.2: Open could not dequeue a packet<BR /><BR /><BR />Your response is highly appreciated.<BR /><BR />Thanks<BR /> Mon, 05 Oct 2009 10:21:36 GMT https://community.hpe.com/t5/server-management-remote-server/ilo2-not-responding/m-p/4507753#M4694 M.S 2009-10-05T10:21:36Z https://community.hpe.com/t5/server-management-remote-server/ilo2-not-responding/m-p/4507754#M4695 If you reboot the server, do you see the iLO option ROM prompt? You might want to shut down and A/C power cycle in order to reset iLO. Then check to see that you are running current iLO 2 firmware.<BR /><BR /><A href="http://www.hp.com/support/ilo2" target="_blank">http://www.hp.com/support/ilo2</A> Mon, 12 Oct 2009 21:09:43 GMT https://community.hpe.com/t5/server-management-remote-server/ilo2-not-responding/m-p/4507754#M4695 acartes 2009-10-12T21:09:43Z