https://community.hpe.com/t5/server-management-remote-server/ilo-hponcfg-help-please/m-p/4972361#M6146 One of our servers had it's system board replaced recently and the tech could not figure out how to configure ILO after replacement. I have HPONCFG installed and working on the target server, but I am unable to get a response from the ILO in a browser. All I have done is configure a static IP (it is now pingable) and add a user account.<BR /><BR />Is there a way to reset the board to factory defaults? I haven't found a script that does this. Should the web page be enabled by default? Thank you for any help you can provide. I can post configs as well, if desired. Thu, 06 Apr 2006 14:50:01 GMT Tim Toohey 2006-04-06T14:50:01Z https://community.hpe.com/t5/server-management-remote-server/ilo-hponcfg-help-please/m-p/4972361#M6146 One of our servers had it's system board replaced recently and the tech could not figure out how to configure ILO after replacement. I have HPONCFG installed and working on the target server, but I am unable to get a response from the ILO in a browser. All I have done is configure a static IP (it is now pingable) and add a user account.<BR /><BR />Is there a way to reset the board to factory defaults? I haven't found a script that does this. Should the web page be enabled by default? Thank you for any help you can provide. I can post configs as well, if desired. Thu, 06 Apr 2006 14:50:01 GMT https://community.hpe.com/t5/server-management-remote-server/ilo-hponcfg-help-please/m-p/4972361#M6146 Tim Toohey 2006-04-06T14:50:01Z https://community.hpe.com/t5/server-management-remote-server/ilo-hponcfg-help-please/m-p/4972362#M6147 I didn't look very hard. hponcfg /reset was what I was looking for...found it right away. Fri, 07 Apr 2006 15:18:19 GMT https://community.hpe.com/t5/server-management-remote-server/ilo-hponcfg-help-please/m-p/4972362#M6147 Tim Toohey 2006-04-07T15:18:19Z