topic Re: Cannot change nic for PXE in Server Management - Remote Server Management

Cannot change nic for PXE

Penni Nussbaum_2 — Tue, 18 Jan 2005 15:46:23 GMT

I inadvertently disabled NIC 1 for PXE. At the same time, I believe I set the password for Administartor. I now am unable to re-enable the NIC. I reboot the server, press pf10 as requested. It prompts me for a password. I put in the password that I reset, but it says the password is not correct. It then only allows me read access. I did try changing the dip switch for ILO security. When the sever reboots, it warns me security is disabled. However, when I go into the utility, it still prompts me for a password. Any assistance would be appreciated.

Re: Cannot change nic for PXE

acartes — Tue, 18 Jan 2005 23:39:40 GMT

You need to set a different dip switch.

Look for the system maintenance switch, position 5. This is labeled "password" or "power on password" or something similar. Consult the hood label for specifics on your system.

This allows you to enter host RBSU without password. There you can reconfigure the password.

The iLO security override switch disables security to the iLO subsystem and to iLO RBSU. However, this is deliberately different than access to the host RBSU.

Re: Cannot change nic for PXE

Penni Nussbaum_2 — Wed, 19 Jan 2005 08:46:51 GMT

Yes, that fixed my problem. Thanks!