topic Re: Powershell set-hpeilosnmpalertsetting not disabling in Server Management - Remote Server Management

Powershell set-hpeilosnmpalertsetting not disabling

uzimmermann — Mon, 17 Jul 2023 03:47:31 GMT

I upgraded a number of iLO5s to 2.91 and that introduced a separate setting for SNMP v1 Traps, which causes a Security Alert.

I am trying to run this command via powershell:

Set-HPEiLOSNMPAlertSetting -Connection $iloconn -SNMPv1Trap Disabled

But this does not disable the v1 Trap.

Any suggestions? Bug in the powershell module? This is on version 4,.10 which is the latest.

Re: Powershell set-hpeilosnmpalertsetting not disabling

thutchings — Fri, 14 Jul 2023 14:10:19 GMT

Hello,

I am getting the same result in my lab environment. I notice the raw PATCH option via redfish works fine, so that should be a workaround available.

I would recommend opening a formal case to get this looked into.

Regards

Re: Powershell set-hpeilosnmpalertsetting not disabling

eri14 — Tue, 28 Nov 2023 08:59:35 GMT

Hello

If we make iLO settings via PowerShell script, including disable SNMPv1 request & Trap in the alert settings, these are enabled again after the iLO reset.

Testet with single steps in ISE:
After running the command 'Set-HPEiLOSNMPAlertSetting -Connection $connect -SNMPv1Enabled Disabled -SNMPv1Trap Disabled', the settings are disabled. After the ilo reset, both settings are enabled again!

- iLO Version 2.91
- HPEiLOcmdlets 4.2.0.0

It works on hosts with a higher or lower iLO version.

Regards