https://community.hpe.com/t5/server-management-systems/initial-proliant-support-pack-install/m-p/3158886#M293 Setupc is the command line variant. There should eb a setup.exe in the Softpaq. Run that and it brings up the Remote Deployment Utility.<BR /><BR />Using that you can first configure the components, password, trust mechanism etc.<BR />And then deploy the entire softpaq to the machine you're on, or a target machine if desired. Wed, 07 Jan 2004 17:29:08 GMT Rob Buxton 2004-01-07T17:29:08Z https://community.hpe.com/t5/server-management-systems/initial-proliant-support-pack-install/m-p/3158885#M292 When trying to install the Initial Proliant Support Pack, I am getting the following error.<BR /><BR />"Could not execute the tool: Initial Proliant Support Pack Install. No value was supplied for required argument with prompt: Enter drive letter for setupc.exe (i.e. E:"<BR /><BR />I've looked around to see where I need to specify this value but can't find it. Thanks in advance, any help would be appreciated.<BR /><BR />Martin Wed, 07 Jan 2004 16:52:53 GMT https://community.hpe.com/t5/server-management-systems/initial-proliant-support-pack-install/m-p/3158885#M292 Martin C. Wells 2004-01-07T16:52:53Z https://community.hpe.com/t5/server-management-systems/initial-proliant-support-pack-install/m-p/3158886#M293 Setupc is the command line variant. There should eb a setup.exe in the Softpaq. Run that and it brings up the Remote Deployment Utility.<BR /><BR />Using that you can first configure the components, password, trust mechanism etc.<BR />And then deploy the entire softpaq to the machine you're on, or a target machine if desired. Wed, 07 Jan 2004 17:29:08 GMT https://community.hpe.com/t5/server-management-systems/initial-proliant-support-pack-install/m-p/3158886#M293 Rob Buxton 2004-01-07T17:29:08Z