Automatic Event handling - not able to do status changes from critical to normal

Steve_P — Fri, 04 Jan 2008 21:47:32 GMT

Hi All,

I was able to configure the event notification for the severity change from critical to normal. I am wondering if you have successful done one.

Here is the scenario:
Two HBAs in the server

If one of the HBA is disconnected from the SAN switch, I received status changes which is critical. But when I reconnected it I did not get any normal events even though I have setup a normal severity event.

I did get both for the ping event.

Thanks,

Steve

Re: Automatic Event handling - not able to do status changes from critical to normal

David Claypool — Fri, 04 Jan 2008 22:48:12 GMT

You shouldn't rely on status changes to pick that up. If you have your trap destinations set properly, you will get specific events about what is going on, not just status changes. Status polling is just a backup mechanism.

topic Re: Automatic Event handling - not able to do status changes from critical to normal in Server Management - Systems Insight Manager

Automatic Event handling - not able to do status changes from critical to normal

Re: Automatic Event handling - not able to do status changes from critical to normal