https://community.hpe.com/t5/server-management-systems/vcrm-question/m-p/3287919#M3143 With the initial Install of the VCRM services, I set the baseline for 7.00a and went on. However now I would like to add another version that is later and set it for the baseline. Can you point me to the documentation for setting this up? or do I have to reinstall the vcrm to back this off or even upgrade it? Thanks in advance!<BR /> Wed, 26 May 2004 15:54:35 GMT Ken Slaton_1 2004-05-26T15:54:35Z https://community.hpe.com/t5/server-management-systems/vcrm-question/m-p/3287919#M3143 With the initial Install of the VCRM services, I set the baseline for 7.00a and went on. However now I would like to add another version that is later and set it for the baseline. Can you point me to the documentation for setting this up? or do I have to reinstall the vcrm to back this off or even upgrade it? Thanks in advance!<BR /> Wed, 26 May 2004 15:54:35 GMT https://community.hpe.com/t5/server-management-systems/vcrm-question/m-p/3287919#M3143 Ken Slaton_1 2004-05-26T15:54:35Z https://community.hpe.com/t5/server-management-systems/vcrm-question/m-p/3287920#M3144 Open the "System Management Homepage" for the server with VCRM on it. Click on "Version Control Repository Manager". Choose "Upload a Support Pack". Browse to your new support pack and click upload. Once youre done you can get out of VCRM. Now go back to "System Management Homepage" for your VCRM server and choose "Version Control Agent" Choose "Change agent Settings". Click "next" since I assume this stuff is already configured and click the pop down to choose the new Support pack you uploaded and click "Finish". Now go back to "HP Systems Insight Manager" and choose "Configure" then "Replicate Agent Settings" and use the agent settings on the VCRM server to replicate to the other servers. Thu, 27 May 2004 06:37:21 GMT https://community.hpe.com/t5/server-management-systems/vcrm-question/m-p/3287920#M3144 Mike Ludwig 2004-05-27T06:37:21Z