topic Re: SIM does not see VCRM in Server Management - Systems Insight Manager

SIM does not see VCRM

Chris_Coates — Fri, 19 Oct 2012 15:22:21 GMT

I recently installed a new VCRM. In SIM I try to configure a baseline to look at the new VCRM as the default, but the new repository does not show up as an option. If I try to point a SMH to the new repository, it works fine, I need to set the default repository to the new VCRM. Any suggestions?

Thanks

Re: SIM does not see VCRM

Sasko Stefanovski — Sat, 20 Oct 2012 00:52:35 GMT

What version of SIM you are running?

Re: SIM does not see VCRM

Chris_Coates — Mon, 22 Oct 2012 11:41:33 GMT

I am running 7.1

Re: SIM does not see VCRM

AMW80 — Mon, 22 Oct 2012 12:02:02 GMT

Has the new VCRM server been successfully discovered in HP SIM?

Re: SIM does not see VCRM

Chris_Coates — Mon, 22 Oct 2012 12:05:53 GMT

No, it has not, and I am not sure how to force it.

Re: SIM does not see VCRM

AMW80 — Mon, 22 Oct 2012 13:44:13 GMT

It should just be a case of discovering the VCRM server the same as any other server. If a normal discovery job through the console isn't picking up the server, try using the command mxnode -a servername instead.

Once the VCRM server shows up as a system in SIM, be sure to setup the trust relationship (either from the Security Settings in the System Management Homepage on the VCRM server, or by configuring the trust from the SIM console using "Configure or Repair Agents").

You should then be able to see the new VCRM under Options > Software/Firmware > Version Control Repository